A Remote ID broadcast module differs from Standard Remote ID because the module

• A.is built into the aircraft by the manufacturer in every case, and cannot be moved between aircraft.
• B.allows the aircraft to fly beyond visual line of sight by itself, without any waiver, while it broadcasts.
• C.is attached to the aircraft and broadcasts the takeoff location instead of a control station location.

Why

A broadcast module is an add-on device attached to the aircraft, and its broadcast uses the takeoff location rather than the control station location used by Standard Remote ID. The module alone does not authorize beyond-visual-line-of-sight flight.

Source: 14 CFR Part 89 · ACS knowledge area: Applicable Regulations · From the Regulations & Registration practice bank (REG-057).

Practice this category as a full test

More Remote ID Broadcast Module questions

• Under 14 CFR Part 107, a small unmanned aircraft is an unmanned aircraft weighing how much on takeoff, including everything on board or attached?
• A recreational flyer is generally required to register an unmanned aircraft with the FAA when its takeoff weight is
• You plan to fly a 0.4-pound unmanned aircraft commercially under Part 107. Which statement about registration is correct?
• How much does FAA registration cost for one small unmanned aircraft, and how long is the registration valid?
• Where must the FAA registration number be placed on a small unmanned aircraft?